Thingiverse
Notebook Stand Simple
por risxiville
58
Descargas
69
Likes
0
Makes
Simple notebook stand.
2 pieces so it can be printed without support and then put togheter simply by inserting the pin into the stand. You may have to sand a bit the pin to fit it in the stand but I did it like that so it stays in without glue. I pressed it in with a vise.
I used a 1.0 mm nozzle with 2mm walls and 10/15% infill. I suggest printing without cooling and with a bit of brim around so it doesn't warp.
You can put some rubber under it so it doesn't slip on a table.
2 pieces so it can be printed without support and then put togheter simply by inserting the pin into the stand. You may have to sand a bit the pin to fit it in the stand but I did it like that so it stays in without glue. I pressed it in with a vise.
I used a 1.0 mm nozzle with 2mm walls and 10/15% infill. I suggest printing without cooling and with a bit of brim around so it doesn't warp.
You can put some rubber under it so it doesn't slip on a table.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
