Thingiverse
Nottaglock 1.1
0
Downloads
4
Likes
0
Makes
**The model in the picture is version 1.0. Version 1.1 looks a bit different, but the mechanics are the same.** I have not printed version 1.1 yet, so please tell me if there is a problem with the model.
Designed a model pistol for fun. I guess it could be used for cosplay, or even training. It has a working slide and magazine, although no shell ejection.
Materials Needed:
- Any sort of glue. I usually use my hot glue gun for assembly.
- Two 12mm x 5mm circular magnet. Smaller magnets *could* work, but I haven't tested that. Make sure you orient the magnets right when putting them in the grip and magazine.
- One rubber band. There are notches above the trigger guard, you can put the rubber band there and behind the back sights once you have those glued.
Tips for assembly and printing:
- It worked fine in PLA with 30% infill, so doing more or maybe less should be fine, depending on your needs.
- It does need to be printed with supports.
- The only parts that do require gluing are the
Designed a model pistol for fun. I guess it could be used for cosplay, or even training. It has a working slide and magazine, although no shell ejection.
Materials Needed:
- Any sort of glue. I usually use my hot glue gun for assembly.
- Two 12mm x 5mm circular magnet. Smaller magnets *could* work, but I haven't tested that. Make sure you orient the magnets right when putting them in the grip and magazine.
- One rubber band. There are notches above the trigger guard, you can put the rubber band there and behind the back sights once you have those glued.
Tips for assembly and printing:
- It worked fine in PLA with 30% infill, so doing more or maybe less should be fine, depending on your needs.
- It does need to be printed with supports.
- The only parts that do require gluing are the
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
