Novation Launchpad X Stand

This is a remix of @micheleianni86’s Launchpad Mini stand. Shoutout to them for the original design and for allowing remixes. I rescaled and adjusted the proportions so it fits the Launchpad X snugly. The model is split in half with dovetails so it fits on the A1 Mini build plate. Printing Notes:Requires supports. Standard supports were used (default style, 50% overhang threshold, small overhang removal enabled). These settings are included in the provided .m3f file.Printed and tested in PLA Silk. Standard PLA or matte PLA should also work, but may result in a slightly tighter dovetail fit.Best results were achieved using the 0.16 mm “Optimal” profile, which produced the most consistent and snug dovetail fit.Installation Notes:The dovetails are a very tight fit. For best results, place the shorter piece flat on a table and firmly press the larger piece into the dovetail by hand as far as it will go.Once started, use a rubber mallet or another soft, weighted tool to tap it fully flush w