Thingiverse
Novena - CPU fan duct
von gregrob
3
Downloads
7
Likes
1
Makes
A two piece print which is glued together to be a CPU fan duct for a Novena board. The fan is also glued to the assembly, and is oriented to blow downwards.
In the 2nd last picture it shows a 25mmx25mmx10mm fan, but it is meant to use a 25x25x6.9mm fan which would fit inside of a Novena case. The final picture shows it with the 6.9mm fan, glued together, and bolted in place. using the 6.9mm fan it sticks up 2mm above the height of the Ethernet ports, but is still shorter than the GPBB pins.
You need to remove and rotate the stock heatsink, I found removal easy to do with a twisting motion.
This is the 25mmx25mmx6mm fan I used.: http://www.digikey.ca/scripts/DkSearch/dksus.dll?Detail&itemSeq=170037193&uq=635641349248190005
In the 2nd last picture it shows a 25mmx25mmx10mm fan, but it is meant to use a 25x25x6.9mm fan which would fit inside of a Novena case. The final picture shows it with the 6.9mm fan, glued together, and bolted in place. using the 6.9mm fan it sticks up 2mm above the height of the Ethernet ports, but is still shorter than the GPBB pins.
You need to remove and rotate the stock heatsink, I found removal easy to do with a twisting motion.
This is the 25mmx25mmx6mm fan I used.: http://www.digikey.ca/scripts/DkSearch/dksus.dll?Detail&itemSeq=170037193&uq=635641349248190005
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
