Nozzle Cleaning Bit Case

A case for the small drill bits used to clean out hot end nozzles. The hinge is intended to be used with 1.75mm filament as an axle. Filament will be a tight fit, you might need to widen the holes with something. If too many people struggle with that, I'll try modifying that area.
This is intended to be used with small 3mm diameter x 1.5mm deep neodymium magnets in order to keep the case shut, which can be purchased cheap just about anywhere. Just use some super glue to hold em in place.
I got mine here, which are uncommon on their website because it is a bulk surplus purchase, and they usually have imperial measurements only.
http://www.kjmagnetics.com/proddetail.asp?prod=ZD4
1/8" x 1/16" is the closest imperial equivalent and should also work, may be a bit of a tighter squeeze but the tolerance of the hole diameter should still be good enough for that. So for anyone looking to make a smaller and cheaper order with imperial magnets, try this link
http://www.kjmagnetics.com/prodd