Thingiverse
Nucleo 64 Breadboard Holder
von CarminKern
22
Downloads
12
Likes
0
Makes
This holder is for Nucleo-64 and standard breadboards…
The Nucleo is attached with 3x M3 8mm brass spacers. To insert the spacers into the breadboardholder, heat them with a lightner and press it carfully into the breadboardholder.
So that no unnecessary gaps arise,
cut the expansion clip from breadboard.
Then you also fit into the designated opening !!!
The Nucleo is attached with 3x M3 8mm brass spacers. To insert the spacers into the breadboardholder, heat them with a lightner and press it carfully into the breadboardholder.
So that no unnecessary gaps arise,
cut the expansion clip from breadboard.
Then you also fit into the designated opening !!!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
