Thingiverse
Nucleo ST-Link Case
von strv
12
Downloads
4
Likes
0
Makes
A case for Nucleo ST-Link board.
The case can assemble without a screw. Just snap.
The case has holes for USB, SWD port, UART port and LED.
Before installing the board into the case, cut all pin headers except SWD and UART.
In the photo, I modified connector from pin header to JST EH for SWD. This connector is small enough to mount to the position.
The case can assemble without a screw. Just snap.
The case has holes for USB, SWD port, UART port and LED.
Before installing the board into the case, cut all pin headers except SWD and UART.
In the photo, I modified connector from pin header to JST EH for SWD. This connector is small enough to mount to the position.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!