Thingiverse
Numatic George Spray Handle Fixing
por jvalta
3
Descargas
3
Likes
0
Makes
Reinforced spray handle fixing clip for the Numatic George (GVE-370) textile cleaner/vacuum.
I printed this out of PLA, use 1.2mm walls and 0.8mm top and bottom, infill 30-40% to make it strong enough but a little flexible to make it easier to mount and conform better with the tube.
!!NOTE!! YOU WILL NEED A 25MM LONG M5 BOLT WITH THIS, THE ORIGINAL BOLT IS TOO SHORT!!
I printed this out of PLA, use 1.2mm walls and 0.8mm top and bottom, infill 30-40% to make it strong enough but a little flexible to make it easier to mount and conform better with the tube.
!!NOTE!! YOU WILL NEED A 25MM LONG M5 BOLT WITH THIS, THE ORIGINAL BOLT IS TOO SHORT!!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!