Thingiverse
Nunchakus
par benanderson13
4
Téléchargements
2
Likes
0
Makes
The handles are 2 pieces that are joined together with a pin. this should work for any printer this a bed larger than 5.5 inches.
*CUT CHAIN LINKS TO THE DESIRED LENGTH*
When printing the chain, I would suggest you put a brim to reduce the chance of the print lifting off of the bed. supports are not needed.
*some glue will be required to fit the handles together. the pins are smaller than the pinholes to allow for some fault tolerance. expanding gorilla glue, or strong bonding adhesive is recommended.*
Rafts, or supports are not needed
*CUT CHAIN LINKS TO THE DESIRED LENGTH*
When printing the chain, I would suggest you put a brim to reduce the chance of the print lifting off of the bed. supports are not needed.
*some glue will be required to fit the handles together. the pins are smaller than the pinholes to allow for some fault tolerance. expanding gorilla glue, or strong bonding adhesive is recommended.*
Rafts, or supports are not needed
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !