Thingiverse

Nut Spinner 3

by Cycon

7 Downloads

12 Likes

0 Makes

Just messing around and it turned out well, have not printed this one yet but i will soon!

NOTE: Nut size is 1/2 in. so 19mm(flat edge to flat edge)x22mm(point to point),12mmc(Inner Diameter)
NOTE: Bearing size: 22mm(OD)x8mm(ID)x7(Width)
NOTE: If the nut or bearing holes are too small, you can either file it down or use a flame to slowly push it out(nicer finish). For directions to use the flame look at my Nut Spinner 1

fidget fidget hand Spinner fidget spinner Fidget Toy hex nut nut nuts spinner fidget fidget hand Spinner fidget spinner Fidget Toy hex nut nut nuts spinner fidget fidget hand Spinner fidget spinner Fidget Toy hex nut nut nuts spinner

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format

STL

Material

Post-processing

Hardware

Software

Cura, PrusaSlicer, or similar

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Nut Spinner 3

Similar Models

Add to Collection