Slicer Discord
nVidia Shield™ K1 Sun Shield – Modelo 3D imprimible de Thingiverse Thingiverse

nVidia Shield™ K1 Sun Shield

por Wolfie
55 Descargas
43 Likes
1 Makes
Ver Modelo
This is a snap on sun shield holder for the nVidia Shield K1. I don't have an original Shield to test so I don't know if this fits or aligns with it.

When using this, the headphone jack IS covered and can't be used.

This is designed for using the Shield K1 as a display for the DJI Phantom or Inspire series of drones. The center supports are lined up and are the correct width to set into the tablet holder on the RC unit (as seen in the photos). I designed this so the holder can remain on the shield and the sun shade can be removed, folded and slipped along with the tablet into a storage pocket in a case or backpack.

I used standard black poster board and velcro dots from the dollar store (2/$1 poster board and $1 for the dots). Total cost is around $2-$3 including filament.

While I flagged this as a remix, I only used a small section of the edge profile of the original item but I am giving credit for where I sourced the profile.

Sorry for the bad photos, battery was d
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección