Oboe reed tip cutter

This reed tip cutter should be printed with ABS.
Glue gauge insert into slots in base then trim. The insets measure finished reed from 68mm to 72mm.
Adjust the cutting length with the 3mm screw in the reed holder. One turn is 0.5mm. Use the guage marks as a guide. Use a vernier caliper for accurate measurement.

Required parts
50mmx4mm Stainless Steel cap screw cut to 44mm Quantity 2
45mmx3mm Stainless Steel cap screw Quantity 3
12mmx2.5mm Stainless Steel cap screw Quantity 1
4mmx6mmx6mm long Heat set brass threaded insert Quantity 2
3mmx4.6mmx4mm long Heat set brass threaded insert Quantity 3
2.5mmx4.2mmx5mm long Heat set brass threaded insert Quantity 1
4mmx0.4mmx20mm spring Quantity 1
5mmx0.4mmx20mm spring Quantity 2
Single edge razor blade Quantity 1 plus spares
4mmODx2mmID 20mm long PTFE tube (3D printer spare part)