Thingiverse
OBSOLETE: RUMBA controller board mount for 3DR Simple
by darco
1
Downloads
2
Likes
0
Makes
## OBSOLETE
Use [thing:459777](http://www.thingiverse.com/thing:459777) instead.
---------------
Print out two of these and you can then mount a [RUMBA](http://reprap.org/wiki/RUMBA) controller board to the underside of the top of your 3DR Simple, using the existing holes. You need four M3 screws and four M3 washers.
Use [thing:459777](http://www.thingiverse.com/thing:459777) instead.
---------------
Print out two of these and you can then mount a [RUMBA](http://reprap.org/wiki/RUMBA) controller board to the underside of the top of your 3DR Simple, using the existing holes. You need four M3 screws and four M3 washers.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
