Thingiverse
Ocelot ECU Case
von NSS_Motorsport
1
Downloads
2
Likes
0
Makes
Heres just a simple design for a WTMtronics Ocelot ECU.
I have designed it so the ECU is a friction fit. However I added a drop of super glue in each corner of the board for a bit of extra security.
The bracket in the back wall is designed for a bluetooth module. That will require superglue to hold it in place.
The external mounting holes are M6. Designed for cap allen bolts. The lid is designed for M3 and have been designed with threads built in.
The lids have the option of facing up or down. The way I have designed the lid is depending which way the main harness connector is facing. There is a cutout in the lid for the 3mm vacuum hose to pit through. So it is crucial to select the right lid to which way you're facing the ECU.
I have designed it so the ECU is a friction fit. However I added a drop of super glue in each corner of the board for a bit of extra security.
The bracket in the back wall is designed for a bluetooth module. That will require superglue to hold it in place.
The external mounting holes are M6. Designed for cap allen bolts. The lid is designed for M3 and have been designed with threads built in.
The lids have the option of facing up or down. The way I have designed the lid is depending which way the main harness connector is facing. There is a cutout in the lid for the 3mm vacuum hose to pit through. So it is crucial to select the right lid to which way you're facing the ECU.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
