Thingiverse
OctoPrint Control Box
by nagilum
275
Downloads
135
Likes
0
Makes
This box contains a Raspberry Pi running the fabulous OctoPrint / OctoPi, a 5 V power supply and an SSR. It allows you to remotely turn on and off your attached 3D printer, either by using the web interface, by sending G-Code or with a custom system command, which is needed to use the feature through the Telegram plugin.
The two hardware buttons are used to power on/off the printer or send a shutdown command to properly power off the Pi.
Next to the hardware setup you will need to install three additional plugins:
* OctoPrint-Enclosure
* PSU Controls
* System Command Editor
All are available in the Octoprint Repository.
SAFETY WARNING:
This build works with mains voltage which is dangerous and potentially lethal. Only attempt this build if you know what you are doing. I am no electrician, it's all at your own risk!
HINT:
The thumbnail for the PDF schematic somehow does not work with "Show Original". I therefore included a PNG version for quick viewing. Of course you
The two hardware buttons are used to power on/off the printer or send a shutdown command to properly power off the Pi.
Next to the hardware setup you will need to install three additional plugins:
* OctoPrint-Enclosure
* PSU Controls
* System Command Editor
All are available in the Octoprint Repository.
SAFETY WARNING:
This build works with mains voltage which is dangerous and potentially lethal. Only attempt this build if you know what you are doing. I am no electrician, it's all at your own risk!
HINT:
The thumbnail for the PDF schematic somehow does not work with "Show Original". I therefore included a PNG version for quick viewing. Of course you
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
