Oculus Gunstock Controller for Quest 2

Oculus Gunstock Controller for Quest 2

3 Files - 6 parts total (1 x Stock, 2 x handle pieces, 2 x dowel pieces)

Additional Parts Required:

7/8" Dowel (3 ft)
8 x Countersunk Magnets (from McMaster Carr https://www.mcmaster.com/5862K225/)
26 x Small Screws (any will do really)
8 x Zip Ties

Instructions:
1) Insert magnets into the handle pieces and dowel pieces and screw them into place (make sure the screws are flush with the face of the magnet)

2) Zip tie the controller piece onto each oculus controller (see pictures for reference) and trim the zip ties afterward

3) insert the dowel into the end of the stock, slide on the dowel pieces and screw all of these into place

4) play and enjoy!