Oculus Quest 2 Golf+ attatchment

This is my version of a golf attatchment made specifically for my Oculus Quest 2!
I tried to make the design as similar to Deadeye VR's product as possible. So instead of spending $70 I only spent $10! The controller should fit inside the print very snug as I used an official model of the Quest 2 controller as the base of the design.

To assemble:

I went to my local thrift store and picked up a $2 3 iron with a strong graphite shaft [13.5 mm dia.] . Therefore the hole may be too small for a regular steel shaft. I recently added another file for steel shafts [14.7 mm], I do not have a steel shaft at the moment so please let me know if I need to change the diameter or feel free to make your own changes! Just be sure to include a little tolerance. I cut my shaft 12" below the top using a Dremel with a cutting attatchment. To secure the shaft in the print, I used Gorilla Glue Gel and let it sit for a few minutes to bond properly. I have yet to run into any issues doing this.

As fo