Oculus Quest 2 Lens Adapter base

After installing the lens adapters, I found the base is too loose and will slide down until the glasses on adapter touches the lens of Oculus Quest 2. I remixed the original base to make it almost double height and resized it to be a little smaller. Now they work better on my Quest 2. If you print them and found they are still a little loose, you can resize them to 99.75% on X and Y axises in Cura. I also provide another similar base that is smaller. You should print them with TPE. They are tight fit at the beginning but will work. The issue of TPE is, they became loose after a while and therefore I didn't install and use them at the end. So far I am still trying to reduce the glare shown from time to time. Any suggestion is welcome.