Thingiverse
Oculus Rift CV1 Sensor Wallmount
por Gaets
91
Descargas
61
Likes
0
Makes
Hi,
Small but sturdy little wallmount with 59 degrees tilt down...
You need to make fillet with a 1/4 20 tap
and insert the rubber o-ring that came with the sensor and the cable strength relief.
Don't over tighten the sensor...
You can use drywall screws to fix on the wall.
Good Rifting....
Small but sturdy little wallmount with 59 degrees tilt down...
You need to make fillet with a 1/4 20 tap
and insert the rubber o-ring that came with the sensor and the cable strength relief.
Don't over tighten the sensor...
You can use drywall screws to fix on the wall.
Good Rifting....
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
