Thingiverse
Oculus Rift Sensor Wall Mount
von superdave42
5
Downloads
3
Likes
0
Makes
Super simple to print. Gets the Sensors off the table. Use Command Strips or 3M Double side tape.
.25 layer height, .4 nozzle 2 walls, PolyMAX PLA 215°C 75mm/s 15% infill cubic (in Cura 3.5) 5 layers top, 5 layers bottom.
By Super Dave at DC-Concepts.
Print your own, but please to not sell unless you split the profits with me O-o
.25 layer height, .4 nozzle 2 walls, PolyMAX PLA 215°C 75mm/s 15% infill cubic (in Cura 3.5) 5 layers top, 5 layers bottom.
By Super Dave at DC-Concepts.
Print your own, but please to not sell unless you split the profits with me O-o
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
