Oculus Touch Table Tennis Adapter - Split Parts

This is my remix of [Esbowman's excellent model](https://www.thingiverse.com/thing:4225762) All I did was split his file so it could print in two parts and use very little supports. I forget now, but I may have used a few supports on Split1.stl in the arch where the handle of the controller sits, but it's probably optional. I think it could print well enough without supports if your printer can handle fairly typical overhangs. It may turn out a little ugly, but it shouldn't hinder usage.

I thought about utilizing holes and pegs to perfectly line up the halves, but I was eager to start printing and I skipped that step. But once I was finished it was not difficult to line up the pieces and it felt secure and strong without any pegs. I carefully aligned and glued the halves and then wrapped it in masking tape for a couple hours so it could bond well without any sliding.

There's really no danger of it coming apart considering you'll be constantly holding the handle and the controll