Thingiverse
Ocusync Air Box protection
von Shawti
10
Downloads
5
Likes
0
Makes
A protection box for your DJI Ocusync to be strapped on the outside of the drone/RC model (top side).
Comes with a hole for each antenna. The small rectangular holes near the circular holes are for a zip tie to act as a support for the aerial to stay still, at the correct angle and height. This allows the antenne to bend freely without snapping/damaging/pull the rear ports on a crash or drop.
This is a tight fit (by design), as i swap my ocusync module between models on the fly and don't wish for it to be ejected on a crash.
If this is too tight for you, try increasing by 2% scale.
Lots of air holes for ventilation.
Feel free to modify and improve.
Comes with a hole for each antenna. The small rectangular holes near the circular holes are for a zip tie to act as a support for the aerial to stay still, at the correct angle and height. This allows the antenne to bend freely without snapping/damaging/pull the rear ports on a crash or drop.
This is a tight fit (by design), as i swap my ocusync module between models on the fly and don't wish for it to be ejected on a crash.
If this is too tight for you, try increasing by 2% scale.
Lots of air holes for ventilation.
Feel free to modify and improve.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
