Odin II. HueForge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Size is 150x200mm. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.24mm and the Actual Depth is 2.24mm.   It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.   Filaments Used: PLA Anycubic Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA Elegoo + Gray Transmission Distance: 3 PLA Elegoo Basic White Transmission Distance: 7 This print uses 4 unique filaments   Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Blue Gray At layer #13 (1.12mm) swap to Gray At layer #15 (1.28mm) swap to White for the rest.