Thingiverse
Odroid Go Advance Case
by setrin
2
Downloads
2
Likes
0
Makes
###Odroid Go Advance (OGA) case
I designed a simple case for my OGA because i couldn't find anything similar and usable.
It has some tolerance (1-2mm), i plan to add some foam/rubber to minimize shifting inside.
Hook is strong enough to withstand weight of OGA, so it doesn't open even when flipped and shaken.
Can be opened with push on sides of the bottom part, where hook hole is.
For hinge pin i've used paper clip (shown in photo) with 0.8mm diameter. I had to force it there a little, so smaller diameter can do the job as well (can be secured with glue on sides if loose)
Tested with OGA Black edition (with L2, R2 buttons), but original OGA should fit as well.
I designed a simple case for my OGA because i couldn't find anything similar and usable.
It has some tolerance (1-2mm), i plan to add some foam/rubber to minimize shifting inside.
Hook is strong enough to withstand weight of OGA, so it doesn't open even when flipped and shaken.
Can be opened with push on sides of the bottom part, where hook hole is.
For hinge pin i've used paper clip (shown in photo) with 0.8mm diameter. I had to force it there a little, so smaller diameter can do the job as well (can be secured with glue on sides if loose)
Tested with OGA Black edition (with L2, R2 buttons), but original OGA should fit as well.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
