Thingiverse
Odroid HC4 Mac Pro enclosure
8
Downloads
10
Likes
0
Makes
This is a case for 2 full sized hard drives and an odroid HC4. You will need 1/4 inch jam nuts and 1/4 inch threaded rods. Dremel slots into the end of the rods and use that to tighten from the bottom and hold in place while hand tightening the jam nut on the bottom.
The feet are printed in TPU or TPE rubber.
The feet are printed in TPU or TPE rubber.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
