OEM Rear Spool Mount Guide

This part is not really necessary for the function of the OEM rear spool mount. I use the mount on a side mount print I downloaded. I couldn't see it in the back that the spool would ride out to the edge against the mount lip plus it didn't matter because the filament was feed right into the tubing and fed fine. The same could be said for the side mount. It works fine, but I didn't like that the filament was being pulled off of the spool at an angle. It annoyed me even though it didn't affect the function in the least.So I jumped in Fusion 360 and threw together a little brace that a 608 skate bearing can sit on for the spool to rub against. The peg is 8mm as is the center of the bearing, but it still fits loosely where it can be removed, but it doesn't matter. The spool moves slow so it will never fling it off. It's purely cosmetic keeping the spool under the filament tubing and satisfies my OCD. That's all it's for. If you need your OCD satisfied, you&