Office Privacy Sign

(my printer wasn't set properly in the example print, I'd just updated to cura 4.1)

Office privacy sign - allows you to physically set your custom status if you work in an office building. There are small circles centered where the other wedges are, so you can easily turn to a specific wedge (assuming you color them appropriately).

Can magnetically attach to a wall w/ a 1/4" neodymium magnet, or command strips or similar. If you use the magnet, you'll have to hold the front or pluck it off the wall to change it, because there's too much friction to spin just the rear signage.

Print both front and back, then customize the sign (text/color) as you see fit, print it, and cut it out - glue/tape to the flat side of the back piece. I recommend cutting the inside circle with an exacto knife so you can easily center it. The outer edge is largely hidden so you can be rougher there - cut on the inside of the circle or you'll have overhang.

The top of the front print includes a vo