OG AppleTV Remote Airtag case

This model was designed by Makanadumlao, I found it on https://www.thingiverse.com/thing:4851515 (You can find the STL files there). Please stop by thingiverse and show him some love, like his model to support his hard work. The only thing I did was identify a good profile for printing on the Bambu P1S using PLA and Support PLA interface, I am sharing that here. HOW TO REMOVE “Support PLA”:I found it best to remove the standard support first (the PLA that leads up to the “Support PLA” Interface), this gives the “Support PLA” interface room to flex away from the printed model (We want to flex the “Support PLA” -NOT the model itself). With all the standard support removed, start pushing the interface away from the underside of the print around the airtag hole, slowly peel it off the model and this thing should fit like a glove for the non-Siri model remotes. Note to the author: If you decide to upload a profile I will take this one down, just private message me to let me know, thanks :)