Thingiverse
Oil Bottle Cap
von Bafflel
0
Downloads
2
Likes
0
Makes
Printer on a Creality HI
.2 mm layer, 3 wall, 15% infill, you can use more infill if you want..
I used PLA but it's not recommended for long term on brake fluid.. ( I just needed this to fill my master cylinder on the bike) so use the proper filament for your application..
I picked up 3/8" OD X 1/4" ID plastic hose at Tractor Supply
.2 mm layer, 3 wall, 15% infill, you can use more infill if you want..
I used PLA but it's not recommended for long term on brake fluid.. ( I just needed this to fill my master cylinder on the bike) so use the proper filament for your application..
I picked up 3/8" OD X 1/4" ID plastic hose at Tractor Supply
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
