Okay, run, dada-dan

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 116.48x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 1.9mmFilaments Used: PLA+ Sunlu Black Transmission Distance: 0.6 PLA PolyLite White Transmission Distance: 5 PLA BambuLab Basic Red Transmission Distance: 4This print uses 3 unique filamentsSwap Instructions: Start with Black At layer #9 (0.8mm) swap to White At layer #18 (1.52mm) swap to RedThis slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it. At layer #23 (1.92mm) swap to Black for the rest.