OLED SSD1306 .96" display case (snap top)

THIS DESIGN NEEDS UPDATING - NOT ALL PRINTS WILL SNAP SHUT CHANGING IT SOON.

OLED display case for the more and more popular 128x64 SSD1306 which are all over AliExpress, E-bay, and Banggood. I spent a lot of time trying to get it to be a snap enclosure and it works most of the time but once in a while I will get a print that i can't make snap, but that could be my printer or settings. Access port in back fits the i2c type (4 pin) connector.

Please test the snapping pressure, several times, BEFORE you put your display in it and squish it! This is a crucial step because sometimes they print so tight that you have to snap the heck out of them and really squish them to get them to snap then pry it open and do it again until it becomes easier. The tiny fingernail slot on the side is barely visible but will help you pry the beasty open later on.

There is not a lot of room left over - Will it get hot in there? - dunno. So far mine are fine.

The tiny screw holes inside the