Cults3D
Game
Go to Model
Olight Odin Protector
0
Downloads
0
Likes
0
Makes
This design is compatible with the Olight Odin series. I have tested the fitment and use this design on: Odin, Odin S and Odin GL.
The protector does not affect the spotlight of the Odin nor the laser on the Odin GL. However, the light spill is reduced and has a honeycomb pattern.
I have based the design off my successful sight kill flash as not only are they BB resistant but a popular design (https://cults3d.com/en/3d-model/game/lpvo-kill-flash-scope-protector & https://cults3d.com/en/3d-model/game/1x22-kill-flash-scope-protector). I have not been able to test the print to the same standards however it has held up to 5 shots point blank in the same location at 1.2j with 0.4g BBs before failure.
The design has a 3mm air gap to the front glass with vent holes around the exterior to prevent thermal build-up and damage to both the torches and the print.
The protector is a tight friction fit, allowing for the protector to be swapped when damaged while not falling off during u
The protector does not affect the spotlight of the Odin nor the laser on the Odin GL. However, the light spill is reduced and has a honeycomb pattern.
I have based the design off my successful sight kill flash as not only are they BB resistant but a popular design (https://cults3d.com/en/3d-model/game/lpvo-kill-flash-scope-protector & https://cults3d.com/en/3d-model/game/1x22-kill-flash-scope-protector). I have not been able to test the print to the same standards however it has held up to 5 shots point blank in the same location at 1.2j with 0.4g BBs before failure.
The design has a 3mm air gap to the front glass with vent holes around the exterior to prevent thermal build-up and damage to both the torches and the print.
The protector is a tight friction fit, allowing for the protector to be swapped when damaged while not falling off during u
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
