Thingiverse
Olson Mask template for Prusa Mini
von Adowoowoo
1
Downloads
1
Likes
0
Makes
Shout out to @PaulMakesThings and @Calaverajoe for posting the originals as I was making masks using card stock.
Face piece didn't scale to 134% and fit on Prusa Mini bed. Tinkercad and some superglue to the rescue.
======
Some 3D printable templates made off of the sewing pattern for olson masks.
Instructions: User calaverajoe noted that scaling to 108% seems to work for child size, 134% is good for an adult. I suggest you lay them flat, and only scale X and Y, or after scaling, unlock the scale and put Z back to 3mm or 100% since extra thickness isn't needed.
Sewing instructions here
https://www.regmedctr.org/webres/File/OlsonMask_wPattern_v3-USE%20THIS%20ONE.pdf
The rings will helpfully make it easier to hold down while you cut.
Face piece didn't scale to 134% and fit on Prusa Mini bed. Tinkercad and some superglue to the rescue.
======
Some 3D printable templates made off of the sewing pattern for olson masks.
Instructions: User calaverajoe noted that scaling to 108% seems to work for child size, 134% is good for an adult. I suggest you lay them flat, and only scale X and Y, or after scaling, unlock the scale and put Z back to 3mm or 100% since extra thickness isn't needed.
Sewing instructions here
https://www.regmedctr.org/webres/File/OlsonMask_wPattern_v3-USE%20THIS%20ONE.pdf
The rings will helpfully make it easier to hold down while you cut.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
