Thingiverse
Olympus E-P7 grip
von drosen
1
Downloads
1
Likes
0
Makes
Grip for the Olympus / OM-System E-P7 camera.
There is a hole for a tripod screw on the bottom, this should ideally be tapped with a 1/4-20 tap. The second partial hole is designed to fit a brass 1/4-20 insert.
I've included the original OpenSCAD file should you need to make changes to the design.
Caution: Be very gentle with the Battery door / cutout. Pushing too hard on the battery door of the camera can cause it to pop off. Usually it can popped back into place, but I take no responsibility for your camera. If this doesn't work for you, feel free to customize the design as needed.
There is a hole for a tripod screw on the bottom, this should ideally be tapped with a 1/4-20 tap. The second partial hole is designed to fit a brass 1/4-20 insert.
I've included the original OpenSCAD file should you need to make changes to the design.
Caution: Be very gentle with the Battery door / cutout. Pushing too hard on the battery door of the camera can cause it to pop off. Usually it can popped back into place, but I take no responsibility for your camera. If this doesn't work for you, feel free to customize the design as needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
