Thingiverse
Omni-Wheel
von BLNorris
63
Downloads
67
Likes
0
Makes
This is an omni wheel for a robot or whatever.
It uses 608 bearing in the rollers, so youll need 6 for each wheel.
Also an 8mm axle, either a threaded or smooth.
I plan to print this out and thread the holes in the rollers, then use a threaded axle and a little glue to keep it in place.
It uses 608 bearing in the rollers, so youll need 6 for each wheel.
Also an 8mm axle, either a threaded or smooth.
I plan to print this out and thread the holes in the rollers, then use a threaded axle and a little glue to keep it in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
