Thingiverse
on-target funnel targets
0
Download
3
Likes
0
Makes
This on-target fixture was designed for the [6-Shot Disc Shooter](https://www.thingiverse.com/thing:6394708) by uhltimate but can be used with other things.
These are filled with frustration and success. The spin on the disk will deny you a win or accelerate you disk out the back.
# Printing
+ These are thin wall fixtures.
+ Good layer adhesion required
+ designed for .4mm at 2mm layer.
+ Frames print face down
+ Remove the support material from the springs
+ Print the cut template
# CUTTING the box
+ Cutting holes could be dangerous. Use caution to avoid personal injury. Certain power tools may be facilitate cutting.
+ For this one you will need the template.
+ Cut on the lines. knock out the plug and insert the fixture.
# The box:
+ 3-7mm thick is good.
+ Less than 3mm you may need to place the templates in the back to make the space behind the clips closer.
# Other models:
[on-target flip and swings](https://www.thingiverse.com/thing:64895
These are filled with frustration and success. The spin on the disk will deny you a win or accelerate you disk out the back.
# Printing
+ These are thin wall fixtures.
+ Good layer adhesion required
+ designed for .4mm at 2mm layer.
+ Frames print face down
+ Remove the support material from the springs
+ Print the cut template
# CUTTING the box
+ Cutting holes could be dangerous. Use caution to avoid personal injury. Certain power tools may be facilitate cutting.
+ For this one you will need the template.
+ Cut on the lines. knock out the plug and insert the fixture.
# The box:
+ 3-7mm thick is good.
+ Less than 3mm you may need to place the templates in the back to make the space behind the clips closer.
# Other models:
[on-target flip and swings](https://www.thingiverse.com/thing:64895
AlwaysTinkering pubblica anche su
153 modelli aggiuntivi su altre 2 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
