One Blank Atari Key Cap Remixed

This is a remix of an Atari ST Key Cap, the original design was done by Nexus3007 , this needs support for the key cap, the original design was too weak in the socket for the stem, so I put a little ring around the socket , just like in the original key caps from the Atari ST, should print nicely on an Ender 3 V2 printer, but I use a $4000 Cubicon to print it, and at 100 percent infill to make it stronger, however one key takes 498 mins to print , and I don't know if it is sturdy enough to last the stress of typing. The letters will be stenciled on the cap Just like on the original key caps on the Atari ST.