OnePlus 13 MagSafe-Case Wireless Charging Stand

This is a sturdy wireless charging stand specifically designed to fit the OnePlus 13's unique geometry and hold it steady when touching the screen. The phone drops into place in both portrait and landscape mode. The stand geometry will also align bare phones and non-magnetic cases with the wireless charging coil, however more bulky cases ( > 81.5mm wide) may not fit in the portrait slot.

The stand has a snap in slot for a generic 60mm diameter x 8.6mm thick MagSafe/Qi charging puck commonly found on Amazon. Larger charging pads interfere with the phone's camera ring.
The charger disk is inserted edge-first through the back, up into the angled notch, then levered into place past the retaining ridges. No tape or glue is generally required. Be sure to align the charger's port with the cable slot at the bottom of the holder. Excess USB cable slack can be tied up and stored below the stand.

I wanted a stand that didn't slide around or tip over, so I recommend adding adhesive backed rubber