MakerWorld
Gadgets
Zum Modell
OnePlus 6 Rear Camera Cover
1
Downloads
0
Likes
0
Makes
SummaryA sliding window camera cover for the OnePlus 6 that is held in place by the phone's case (the official case that comes with the phone), so you don't have to glue it to the phone.Print Settings A GCODE file for the Creality Ender 3 ready for print is included Print all 3 STL files:Cover.stlRail-bottom.stlRail-top.stl It is important to change the line height to 0.1 since this is a very thin print and every layer counts. In addition, in order to successfully print this, I tinkered with the slicing settings and ended up with the following custom settings: Initial Layer Speed: 10 mm/s (important) Initial Layer Flow: 120% (might have made a difference)Flow: 120% (might have made a difference)Printing Temperature: 205C (might have made a difference)A friendly tip: When the print is done, don't remove the parts off of the printer's bed before letting it cool off a bit. The parts are very thin and might get deformed in the process.If they did get deformed while removing them from the p
TheYarin veröffentlicht auch auf
9 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!