OneWheel Car Stand

***UPDATE*** I just added a single print file as well, in case you have a larger 3D printer and would rather print this all at once.

I wanted a stand for my Onewheel plus for when it's in the car so it won't roll around when turning or stopping the car. My solution is this 2 part concentric circle model made in Fusion 360. To print as one large piece would have been slightly too large for my MakerBot Replicator 5th Gen., so I split it into two and made a puzzle piece-like connector system that worked really well.

To ensure a good interference fit, I reduced the size of the male puzzle parts by 0.1mm all around and that worked well. I also made a puzzle piece test piece to print first to make sure the fit was good. I'm including this test print file as well and recommend to print 2 of these before committing to the entire OneWheel stand print, as each OneWheel Stand piece took 17 hrs @ 0.2mm resolution.

I also included 5 pre-drilled holes, in case I wanted to add rubber feet o