Thingiverse
Oni Swift Strike Stand
by Zakybub
16
Downloads
7
Likes
0
Makes
This stand is made to fit the Oni Genji Swift Strike sword when printed at 52%. The stand can be scaled up 2x to fit the full size sword.
The sword is found here: https://www.thingiverse.com/thing:2601341
It is printed in two parts. The base should be printed upright with no supports. The stand should be printed on it's side with 55-degree supports everywhere. Wall thickness can be anything from 0.8mm and I like to print supports >=15% gyroid. Layer height is good at 0.15-0.2mm.
The sword is found here: https://www.thingiverse.com/thing:2601341
It is printed in two parts. The base should be printed upright with no supports. The stand should be printed on it's side with 55-degree supports everywhere. Wall thickness can be anything from 0.8mm and I like to print supports >=15% gyroid. Layer height is good at 0.15-0.2mm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
