OnlyGnomes: Blossom

It's OnlyGnomes model Blossom! Supports required. Model clippers/snippers recommended. Supports remove easily. Note: because this model has a large portion at a 90-degree angle to the print bed there will be very visible interface lines on the underside where the supports are and some visible layer lines along the top. If you are ok with that then print the model as it is in the profile. If you want smoother surfaces all around, the best way I found was to rotate the model with the top of the hat towards the print bed. Adjust to eliminate as many flat bottom and top surfaces as possible. It's very important to have a good clean bed for good adhesion if you print it this way. The hat where it touches the bed will need a little sanding to smooth. Something approximately like this: Check my collections for other related models. Check my profile for my other models and follow for many more to come. Don't forget to leave a review and toss me a boost if you think I deserve it. En