Thingiverse
Music
Go to Model
Open Theremin V4 Enhanced Case
17
Downloads
9
Likes
1
Makes
This case is intended for the Open Theremin V4: https://www.gaudi.ch/OpenTheremin/
It is a derivative of the original case, with wings added to support the antennas and cover their mounting plugs. It also features a 3D printed front plate to cover the PCB and help support the knobs and grounding clip.
Notes:
The M3 screws used to assemble must have heads with a diameter less than 5mm. This is true of the screws that come with the theremin, however, the screws I had on hand were too wide. You will need four screws beyond what comes with the Basic kit, or no extra screws if you have the Deluxe kit.
The knobs are designed to fit into recesses in the top plate. This provides a bit more support against impacts, protecting the PCB. However, it also means other knobs may not work well with this design.
It is a derivative of the original case, with wings added to support the antennas and cover their mounting plugs. It also features a 3D printed front plate to cover the PCB and help support the knobs and grounding clip.
Notes:
The M3 screws used to assemble must have heads with a diameter less than 5mm. This is true of the screws that come with the theremin, however, the screws I had on hand were too wide. You will need four screws beyond what comes with the Basic kit, or no extra screws if you have the Deluxe kit.
The knobs are designed to fit into recesses in the top plate. This provides a bit more support against impacts, protecting the PCB. However, it also means other knobs may not work well with this design.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
