Thingiverse
Openable Heart-Shaped Container
door 3DTwinkie
86
Downloads
75
Likes
0
Makes
This is my Heart-Shaped Pokeball.
A random idea I had. This heart container has a hinge to allow it to open/close, with 2 notches in the front of the box to allow it to snap-shut. No external hardware required. This also prints with no supports being needed at all.
Additionally included is a little message if you want to print it.
The hinge works as a hole that fits a standard 1.75mm strand of filament through.
There are notch slots for the middle hinge to fit into the bottom heart piece.
The pieces are split to colour each part (Red for the top heart, black for the middle hinge, white for the bottom heart. Black then white for the middle button piece.).
A random idea I had. This heart container has a hinge to allow it to open/close, with 2 notches in the front of the box to allow it to snap-shut. No external hardware required. This also prints with no supports being needed at all.
Additionally included is a little message if you want to print it.
The hinge works as a hole that fits a standard 1.75mm strand of filament through.
There are notch slots for the middle hinge to fit into the bottom heart piece.
The pieces are split to colour each part (Red for the top heart, black for the middle hinge, white for the bottom heart. Black then white for the middle button piece.).
3DTwinkie publiceert ook op
122 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
