Thingiverse
OpenForge 2.0 Flatbed Mine Wagon
von Alonicus
217
Downloads
112
Likes
0
Makes
This is a remix of the OpenLock flatbed mine wagon I made.
The original was designed to fit the OpenLock track Melabam made. This one uses the same bodies but with new wheels and axle clamps, to fit the OpenForge mine railway Devon Jones created.
The two are very similar, but the OpenForge track is slightly narrower and has less gap between the top of the sleepers and the top of the rails. These new wheels will fit both the OpenForge and OpenLock track.
Unlike most mine carts out there, these are designed so you can stand 28mm figures on them. It's slightly less realistic, but makes them far more useful as gaming pieces !
The bodies and axle clamps should print without supports, but you may need to experiment with the wheels to see whether your printer prints them better upright or lying down, and will probably need at least a few supports (and some clean up !) either way.
My original minecarts are https://www.thingiverse.com/thing:3831161
Devon's OpenForge track i
The original was designed to fit the OpenLock track Melabam made. This one uses the same bodies but with new wheels and axle clamps, to fit the OpenForge mine railway Devon Jones created.
The two are very similar, but the OpenForge track is slightly narrower and has less gap between the top of the sleepers and the top of the rails. These new wheels will fit both the OpenForge and OpenLock track.
Unlike most mine carts out there, these are designed so you can stand 28mm figures on them. It's slightly less realistic, but makes them far more useful as gaming pieces !
The bodies and axle clamps should print without supports, but you may need to experiment with the wheels to see whether your printer prints them better upright or lying down, and will probably need at least a few supports (and some clean up !) either way.
My original minecarts are https://www.thingiverse.com/thing:3831161
Devon's OpenForge track i
Alonicus veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
