Thingiverse
OpenForge OpenLock Pass-Thru Clips
by MarcCCTx
517
Downloads
213
Likes
2
Makes
The normal A-Wall or Floor is an edge. I wanted a door, partition, extension or spacer that could clip to both sides. The clip is a normal shortestleg clip stretched out (the hole if for added print strength). And the tiles, sizes A and IA, have a pass-thru, but still allow it to sit atop a wall.
Now with a slimmer clip to make it easier to fit between the wall's upper studs.
2/28/2020: Added two new pieces A-TRP-v7.001_passthru and Passthru_clip_v8 to match more modern pieces.
06/22/2020 Added the two slightly springy versions
Now with a slimmer clip to make it easier to fit between the wall's upper studs.
2/28/2020: Added two new pieces A-TRP-v7.001_passthru and Passthru_clip_v8 to match more modern pieces.
06/22/2020 Added the two slightly springy versions
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
