Thingiverse
OpenForge Stone Flicker LED Torch Wall - Simplified
164
Download
110
Likes
0
Makes
I really liked the flicker LED torch walls but all the ones I found were way more complex than they needed to be. I made this torch wall as a self contained unit with three printable pieces, the 3mm flicker LED, a common CR2032 battery holder, and some tiny wire (30ga I think).
The top of the wall comes off and you can easily remove the battery to turn it off without messing with your layout. You don't have to take the tile out of your layout to get to a switch on the bottom. The switch is unnecessary since it is just as easy to slide the battery in an out. You can use this wall as a separate wall with the separate bases or you can replace the standard wall on the integrated wall/base tiles.
You may find it necessary to print the pieces with a brim. No supports are needed. This has some fairly thin walls near the battery holder so you should use a .5mm nozzle or smaller. Some filling of the walls may be necessary for a good fit of the top and bottom piece since the tol
The top of the wall comes off and you can easily remove the battery to turn it off without messing with your layout. You don't have to take the tile out of your layout to get to a switch on the bottom. The switch is unnecessary since it is just as easy to slide the battery in an out. You can use this wall as a separate wall with the separate bases or you can replace the standard wall on the integrated wall/base tiles.
You may find it necessary to print the pieces with a brim. No supports are needed. This has some fairly thin walls near the battery holder so you should use a .5mm nozzle or smaller. Some filling of the walls may be necessary for a good fit of the top and bottom piece since the tol
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
