Openlock Magnet Clip Create Tool

These are two tool two help with creating magnetic clips for openlock.
The drill case can hold up to 10 clips that you hold in place with the drill bar. Then you can drill the 10 clips and when done you can use the drill pusher to push the prepared clips out.

The Clip Tool Holder you need to place to 3x3 magnets in, in opposite pole position. So one magnet N-S and the other S-N. There are small holes in the bottom through which you can push them out if needed.
Then when done you place two magnets on top of them (which will go into openlock mag clip)

In the Clip Tool Pusher you place the magnetic clip and then slide everything in the the clip tool Holder, then push the magnets in the clip. Drag it out and if the magnets are not fully in you slide the pusher in the holes on the back of the holder so you can push the magnets in.

Leave a comment if you have problem figuring this out!