Thingiverse
OpenPilot GPS v9 holder
door jkoljo
17
Downloads
14
Likes
0
Makes
Print it out, use 8 mm rod and assemble with CA glue and a few nylon bolts and washers. This model has already successfully protected my GPS from a few crashes, and does not obstruct the signal.
The LEDs on the GPS are visible from above and side when using this holder.
The LEDs on the GPS are visible from above and side when using this holder.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
