Thingiverse
Optic Rail Mount for S&T Type 64
by SaucyPantsu
0
Downloads
0
Likes
0
Makes
These are my optic mount designs for the S&T Type 64 AEG.
It takes Mlok rails, the ones that have the 80mm centre to centre of the holes in the rail.
The Mk1 is offset to the left by about 10 mm to make it easier to use with goggles.
The Mk2 is just about centre lined and has smaller holes that are easier to tap to use Mlok bolts in it.
The Mk4 is the same as Mk2 but reinforced to allow PLA to be used effectively.
I printed mine in PLA at 50%, but I recommend 70%+ for extra stiffness. I do not know if this will fit on the G&G Type 64, but if anyone who has one can test it and find out, I would be happy to hear and update this post to reflect compatibility.
It takes Mlok rails, the ones that have the 80mm centre to centre of the holes in the rail.
The Mk1 is offset to the left by about 10 mm to make it easier to use with goggles.
The Mk2 is just about centre lined and has smaller holes that are easier to tap to use Mlok bolts in it.
The Mk4 is the same as Mk2 but reinforced to allow PLA to be used effectively.
I printed mine in PLA at 50%, but I recommend 70%+ for extra stiffness. I do not know if this will fit on the G&G Type 64, but if anyone who has one can test it and find out, I would be happy to hear and update this post to reflect compatibility.
SaucyPantsu also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!